Development of the powder reaction moulding process

Lei Zhao, Maurice N. Collins, Colin Birkinshaw

Research output: Contribution to journalArticlepeer-review

Abstract

Background: The powder reaction moulding process uses a reactive monomer as carrier and binder for the moulding of metal or ceramic powders. De-binding is achieved using thermal depolymerisation which is followed by sintering to give the finished component. Binder can be recovered for re-use. Results: Moulding compounds, with various powder volume fractions, have been prepared using stainless steel, silicon nitride and alumina with n-butyl cyanoacrylate as binder, and the stability of the compounds established. Rheological properties of the compounds have been measured using both pressure flow and drag flow methods. Compounds are strongly pseudoplastic. Comparison of experimental results with theoretical models, describing suspension flow behaviour shows that experimental maximum volume fractions are close to the theoretical volume fraction of 0.42 for silicon nitride, 0.68 for alumina and 0.7 for stainless steel. Differential scanning calorimetry and thermogravimetry have been used to simulate de-binding and show a rapid loss of binder through depolymerisation. Post-sintering porosity of the ceramic materials is high but this is thought to arise from the low pressure moulding techniques used. Porosity of the stainless steel mouldings is much lower. Conclusions: The results validate the powder reaction moulding idea and demonstrate applicability to three widely different powder materials.

Original languageEnglish
Pages (from-to)454-460
Number of pages7
JournalJournal of Chemical Technology and Biotechnology
Volume84
Issue number3
DOIs
Publication statusPublished - 2009

Keywords

  • Compression forming
  • Cyanoacrylate
  • Moulding
  • Powder forming
  • Sintering

Fingerprint

Dive into the research topics of 'Development of the powder reaction moulding process'. Together they form a unique fingerprint.

Cite this