Interpretation of creep crack initiation and growth data for weldments

Creep crack growth testing of macroscopically homogeneous materials is well established and standardised test procedures are detailed in ASTM E1457. In ASTM E1457 the use of the compact tension C(T) specimen is specified and crack growth data are interpreted using the fracture mechanics parameter C^*. The resulting benchmark crack growth data are used in assessment procedures, together with estimates of the value of C^* in the component, to predict creep crack growth behaviour. In this work, the results of a series of creep crack growth tests performed on a Type 316 stainless steel weldment at a temperature of 550 °C are presented. The initial crack is located within the heat affected zone (HAZ) of the weldment. Since there are currently no agreed methods for determining C^* in inhomogeneous laboratory specimens, this paper examines the application of procedures in ASTM E1457 for the characterisation of crack growth in weldments. In addition, the creep toughness parameter K_mat^c is evaluated for the material. It is shown that the creep crack growth rates in the weldment may be described by the C^* values obtained following ASTM E1457 in conjunction with parent material properties. Comparison of the results with similar data for Type 316H stainless steel parent material shows that the crack growth rates for the crack located within the HAZ are higher and the initiation times lower than the parent values, for the range of test conditions examined. Simple analytical models based on ductility exhaustion arguments have been shown to bound the crack initiation and growth data for the weldment.